Laing E6 and E10 rotor assembly, Ø 80 mm

This rotor assembly has a maximum diameter of 80 mm and is the only moving part for the Laing E6 pump and some E10 pumps (including the 1" barb and 3/4" MPT models, among others).

Check the dimensions of the rotor assembly you want to replace, as we also offer a different model compatible with E10 pumps but with a diameter of 68 mm. These two models are not interchangeable.

This kit includes the impeller, the magnetic section and the carbon bearing, as well as the o-ring. It is a one piece unit that cannot be dismantled further.

The rotor assembly allows you to repair the pump if it fails due to dry running or carbon bearing failure.

Before any replacement, clean the rounded and magnetic part of the rotor and motor assemblies thoroughly: in some cases, a simple cleaning may explain the failure. Also make sure that the ceramic ball of the motor is intact and undamaged. Otherwise, you will have to replace the entire pump.

Dimensions
Diameter: 80 mm
Height (including white part): 42 mm
Diameter of the white part: 61 mm
O-ring (outer diameter): 89 mm