Gecko pressure switch cable

This cable connects the pressure switch to the motherboard of your control system. This specific part is found on most Gecko MSPA et TSPA systems, but it can be used with other systems as well.

If your cable is damaged then you may get flow detection errors (like FLO, or three flashing dots), even though the pressure switch works perfectly.

Dimensions
Cable length: 33 cm

Connections
Pressure-switch end: 2 spade connectors
Motherboard end: a 3-socket female plug, with 2 wires (one socket is not used)

Part numbers
Gecko: 9920-400124
Sunrise Spas : WTY50082