Waterway Viper single-speed pump

The Waterway Viper single-speed pump is used by many spa brands, for massage jets and to generage a fast-moving current in swim spas. It has a 3.0 HP EMG Italian-made water-resistant motor and a high-performance wet end with a 5.0 HP impeller.

Dimensions
Length: 430 mm
Width: 210 mm
Height: 250 mm

Plumbing Connections
Both the intake and outflow are male threaded with a 94 mm outside diameter. This pump is normally connected to 2-inch pipes. We also offer unions for 2.5-inch pipes.

Technical data
Power: 2,9 kW (3 HP)
Current: 12,4 A
Maximum flow rate: 68 m³ / hour

The new Viper models are more powerful, and perfectly replace the old models with lower power.

Cables and plugs
The Waterway Viper pump is delivered without plug and cable. If you are replacing an existing pump, you may be able to re-use your existing power cord. There is a wiring diagram for connecting it up on the inside of the cover of the water-resistant electrical box.

You can also choose to have the pump pre-wired by our team with an AMP plug or a mini J&J plug.

An in.link plug (220 cm long) is also available, but we recommend that you keep your existing cable if it's in good condition. Your pump may indeed be defective for many reasons, but the power cable is rarely to blame.

Similar pump
The Aqua-Flo Flo-Master XP3 pump has the same motor power and thread size as the Viper, and roughly similar dimensions. Please note that if you want to replace your pump with another model, you must check the use of space and the fixing distances as pipe connection adjustments may be necessary.

Warranty
2-year Tubs Parts warranty

Waterway part numbers
Assembly: 3722022-CE
Assembly : PV-30-1N22X
Wet end with a 5HP impeller: 310-0180