HydroAir wall fitting

Use this short wall fitting on thin-walled spas, to fix in place a strip skimmer or a suction fitting. To install a strip skimmer, you just need to press the vertical grille against this wall fitting, and screw in the grate to hold in place. To install a suction fitting, simply screw an anti-vortex grille into the wall fitting.

You should fit this part with a gasket and also use silicone. Both the gasket and the silicone should be placed between the wall fitting and the inner wall of the spa.

Dimensions
Diameter to drill (external diameter of thread): 60 mm
Maximum wall thickness: 18 mm
Longueur du pas de vis: 25 mm
External diameter of the face: 85 mm
Internal diameter of the thread: 45 mm

Part numbers
HydroAir: 10-3801